STUDDED CHEYENNE HOLSTER
For Colt S.A. 7-1/2" or the 4 3/4 - 5 1/2" barrel. . With sewn in toe plug.
Each...... $45.00
TRANSITIONAL HOLSTER
These holsters must be wet fit for best results. They are designed for a very
snug fit. They are designed to trap the trigger guard of the revolver under the
back trigger guard curve of the holster as was done on the original. See enlargement.
For 58 Remington, 51 Navy, 61 Navy, 60 Army and many conversions.
The Remington with its tall front site is somewhat difficult to fit.
Wet forming it and using a broom stick handle to stretch and shape the barrel
area is a big help.
Fits 7 1/2 and 8 inch barrels. $39.95
2-3/4" wide. Fits 12 gauge shotgun shells or Revolver .38-40, .44-40, .45 Colt cartridges or Rifle ammo .30-30, .45-70, .45-60.
How to treat your leather
After you receive your holster it's important to "shape" the holster to your gun. Soak the holster in a bucket of warm water for about 3 seconds then place your well oiled gun in a bread bag and insert in holster. Now using your thumbs work the leather around and over your gun pressing firmly into all bumps and valleys. The more you work it the better it will look. Then remove your gun and bread bag and allow to dry thoroughly about 24 to 48 hours. DO NOT dry the holster with the gun in it. A light oiling on the inside and outside may be necessary if the leather is a little on the dry side. You can use neatsfoot oil, mink oil, snow seal any number of leather oil treatments.